Reply To: Planing End Grain

Reply To: Planing End Grain 2015-07-19T10:47:00+00:00
Bill
Participant
Post count: 72

To ensure you plane to length and keep it square (while minimizing tear-out), you can try the following:

With a knife, scribe your finish line around the circumference of your board – both faces, both edges – transferring the knife line from your initial reference face as you go.  You can then chamfer along the edges with a block plane – or whatever you have available – down to that line.  Then plane the middle  (the portion of end grain that remains “above” your line) until it is flat across the end grain face.  I hope that makes sense…  It’s the slickest way I’ve seen to plane a long piece of end grain without the fear of any tear-out – think I saw it on a Chris Schwartz video – maybe Paul Sellers – I can’t remember.

The suggestion to use mineral spirits works well, too.  I prefer an oil-rag can instead of the wax on plane soles, however.  I’ll post a topic on that since I received a question via my website about it.

 

Wood and Shop in your inbox?

Subscribe to get Joshua's free traditional woodworking videos, articles & news:

You have Successfully Subscribed!