Tuning Joiner Plane

//Tuning Joiner Plane
Tuning Joiner Plane 2015-10-28T11:08:10+00:00
  • Creator
    Topic
  • #2027703

    glasgow1611
    Participant
    Post count: 2

    Is it as important to flatten and tune a joiner planer as other planes?

    reason for question is I am having hard time flattening my No 7 joiner.

  • Author
    Replies
  • Mike in TN
    Participant
    Post count: 258

    Plane flattening

    Hi Glasgow,

    My experience is, if you can place the plane on a known flat surface such as a tested table saw top or a planer bed, have no rock n the plane, can see no backlight anywhere under the sole and/or can’t work a thin feeler gage blade in anywhere along the sole, you are flat enough to do the work, especially when using camber on the blade. Don’t worry about small gaps along the front, back, or side edges since those areas are often eased to facilitated planning anyway. Again, in my opinion, super tuning is best left to smooth planes and some joinery planes and is wasted effort on planes used for general stock removal, especially scrub and fore plane type work. Squaring the sides should be reserved for tools used for shooting and squaring operations where the sides help control the cut. Even with that, some out-of-square-ness can be compensated for through lateral adjustment of the blade.

    Have fun.

     

    1 user thanked author for this post.

You must be logged in to reply to this topic.

Log In
Join

Wood and Shop in your inbox?

Subscribe to get Joshua's free traditional woodworking videos, articles & news:

You have Successfully Subscribed!