Forum Replies Created

Viewing 5 replies - 1 through 5 (of 5 total)
  • Author
    Replies
  • Ken
    Participant
    Post count: 10

    Thank you Sides, I’m about half way through a small napkin holder right now, then I think I’ll try some simple side tables.

  • Ken
    Participant
    Post count: 10

    Thanks for the reply Mike. I flattened the sole and made sure the body was square, tightened everything up and then found out I had ground the edge way out of square. This blade has a very slight taper on both of the side edges. Once I figured this out I was able to re grind the edge closer to square. I can get a consistent shaving now. All I have to do now, is figure out how to plane square :)

  • Ken
    Participant
    Post count: 10
    in reply to: WTB Back Saw #2026782

    I’ve been looking on eBay a lot for one, but like you said the price sky rockets at the last minute, usually far above my limit.

  • Ken
    Participant
    Post count: 10

    My gut was telling me to rough cut before surfacing, but I wasn’t 100% sure.

    Thank you for the replies, I’ll be doing some layout and rough cutting tonight.

  • Ken
    Participant
    Post count: 10
    in reply to: Colorado Blues #2026685

    I’m in the same situation, it’s pretty slim pickings on the west coast.

Viewing 5 replies - 1 through 5 (of 5 total)